Yaskawa MP920 Motion Module - Manual (Page 170)

5 SVA Module Specifications and Handling
5.2.2 Handling
5-28
„ Servo Connectors (CN1 and CN2) j
„ 24 V Input Connector (CN3)
Connect the +24 VDC Servo I/O power supply connector to the SVA-02A Module. Use a
BL3.5/2F-AU Screw Terminal Block Connector (manufactured by Weidmüller).
„ Connector Specifications
The following table shows the specifications of the connectors shown above.
The Servo Connector is used to connect an SVA-02A Servo Module and a
SERVOPACK.
Use the following standard cable for this connector.
• SGDA-†††S SERVOPACKs: JEPMC-W6070-05
• SGDB/SGDM SERVOPACKs: JEPMC-W6080-05
Pin No. Signal Name Pin Name
2 24 V +24 VDC Input
1 0 V 0 V
CN3
+24V
0V
Name Connector
Name
Num-
ber of
Pins
Connector Cable
On Module On Cable Manufac-
turer
Servo
Interface
Connector 1
Connector 2 CN1
CN2 36 10236-52A2JL • Connector body:
10136-3000VE
• Shell:
10336-52A0-008
(Screw lock)
10336-52F0-008
(One-touch lock)
3M JEPMC-W6070-05
(for SGDA)
JEPMC-W6080-05
(for SGDB, SGDM)
24 V Input
Connector CN3 2 − • BL3.5/2F-AU Weidmüller The CN3 connector is
provided with the SVA-
02A Module, but no
cable is connected to
the connector. The user
is expected to connect
the cable to the connec-
tor.