WattMaster WM-WCC3-TGD-01B - Manual (Page 95)

2. INITIATING THE SYSTEM
WCC III Technical Guide 2-27
Webmin Administration - Limited Version
On the Left hand side of the Main webmin page is a very limited
subset of the main webmin program sub-categories. These sub-
categories are used to setup, display, and monitor the operation of
the WCC III – MCD.
MCD Controls See Pages 2-28 to 2-29 for further details. This is
used to turn on and off WattMaster’s Backtask service that should
always be running on the WCC III – MCD.
System See Pages 2-30 to 2-33 for further details. Used to select
and setup the various Webmin administration system options
Search:
Used to search the Webmin application program for a exact specifi c
command, or for general help with the Webmin program.
System Information
This will display the exact same information that is on the right
side of the main menu. See page 2-26.
Logout
This will log you out the Webmin application, and take you back
to the fi rst initial Webmin log in screen. WattMaster Controls, Inc.
only supports the Ubuntu Linux at this time, changing the operating
system will void any and all warranties written or implied that
applies to the operation of the WCC III - MCD.
NOTICE: A knowledgeable computer person should be
used in the setup and deployment of the WCC III – MCD.
This person should also have a good working knowledge
of the Ubuntu Linux operating system and needs to be able
to make changes to the settings other than the WattMaster
Controls factory defaults. These proposed changes should be
sent to WattMaster Controls for written approval before any
changes occur. Failure to having not complied with the above
statements could result in improper operation of the WCC
III – MCD hardware and or software and could cause the
WattMaster Controls control program “Backtask” to function
improperly. Any unauthorized changes will void any and all
warranties, written or implied, that apply to the basic operation
of the WCC III – MCD system.