Scuscr.exe screens, Vav box iii for wcc iii software screens, Vav box iii status screen – WattMaster WM-WCC3-TGD-01B User Manual
Page 327: Wcc iii technical guide 4-17
4. SCUSCR.EXE SCREENS
WCC III Technical Guide
4-17
SCUSCR.EXE SCREENS
The SCUSCR.exe program is used to access stand-alone controllers
that have been preprogrammed with application-specifi c software
such as VAVBOX software, AHU control software, Heat Pump
control software, etc. These screens are displayed the same as the
older WCC II screens.
NOTE:
Only the VAV BOX III software is explained in this
section.
VAV BOX III for WCC III Software
Screens
This is the main summary screen for the WCC3 VAV BOX III
software for the WCC III system and there should be suffi cient
information on this screen that by simply viewing of this screen
an operator can detect if the VAV BOX III controller is operating
correctly or not.
Satellite: Unit:
The satellite fi eld is used to input a valid SAT 3d address number.
The unit number is used to select a valid TUC (Terminal Unit
Controller) that is connected to the SAT 3d controller.
VAV BOX CONTROLLER
Satellite: _ 4
Unit:
1
Location:
Version: 3.04
TYPE OF CONTROL METHOD: XXXXX XXXXX XXXXX
[ STATUS SCREEN ]
[ EXPANSION OUTPUTS ]
{ Optional }
Operating
Mode: OCCUPIED MODE
Space Temp Mode: VENT MODE
Fan Status.......: OFF
Supply Air Mode: COOLING MODE
Heat Relay.......: OFF
Space Temperature...............:
76.2°F
Active Cooling Setpoint.........:
72.0°F
Heat Relay.......: OFF
Active Heating Setpoint.........:
70.0°F
Current Heat/Cool Demand........:
4.2°F
Proportional Heat:
0%
Sensor Slide Adjust...{Optional}:
0.0°F
EMS Effect on Setpoints.........:
0 %
Supply Air Temperature..........:
55.0°F
Discharge Temperature...........:
55.0°F
Airflow.........{Pr.Indep. ONLY}:
0 CFM
Main Fan Status..: OFF
Calculated Damper/Airflow.......:
54%
Damper Position.................:
56%
< Ctrl-RIGHT ARROW > for Setpoints
Screen File: SCR220.SDF
Figure 4-1: VAV BOX Status Screen
Valid SAT 3d addresses are in groups of 4, starting at address 4.
You cannot start a SAT 3d address with a 5, 6, 7, 9, 10, 11, 13,
14, 15 etc. It must be a derivative of address 4, example 4, 8, 12,
16, 20, 24, 28,etc. If there is a question with Satellite addressing,
please check the Satellite summary screen to see if a valid SAT 3d
exists before continuing.
VAV BOX III Status Screen