WattMaster WM-WCC3-TGD-01B - Manual (Page 46)

I. INTRODUCTION
WCC III Technical Guide I-24
TUC/RTU Controller Boards - TUC-5R/TUC-5R+
TUC-5R (TUC-5R+) Controller - ( OE330
and OE331)
The TUC-5R (later boards use the TUC-5R+) Controller is a
Terminal Unit Controller that is used to control a Dual Duct,
Heat Pump, or Constant Volume Air Handler. This TUC-5R has
fi ve onboard relays, hence the -5R. The TUC-5R Controller has
application-specifi c software that was written for the WCC II
system, but this software also works with the WCC III system.
There are currently no expansion boards for the TUC-5R+ that will
work with the application software for the WCC III system.
Common TUC-5R+ WCC software is as follows:
WCC III Heat Pump / CV Air Handler ( SS5011)
Examples of older single operation custom software for the TUC-
5R Controllers are listed below:
Screen File # Description of Software EPROM Label
SCR160.SDF CV AHU w/ Economizer CVAHUT
SCR161.SDF CV AHU w/o Economizer CVAHUT
SCR162.SDF CV AHU CO w/ Economizer CVAHUT
SCR163.SDF CV AHU CO w/o Economizer CVAHUT
SCR151.SDF Demand Meter (Single Input) DEMAND
SCR93.SDF HVFSE (Series Fan w/Slave) HVFSE
SCR201.SDF TUC 5R Universal I/O GLOBAL5R
Controller
Figure I-19: The TUC-5R+ Controller