WattMaster WM-WCC3-TGD-01B - Manual (Page 124)

WCC3.EXE SCREEN DESCRIPTIONS
WCC III Technical Guide 3-10
The Main Menu Screen allows you to view the available screens
within the WCC III system. To get to a screen listed on the Main
Menu, use the arrow keys to position the cursor over the name of
the screen you want to access and press
.
The Main Menu is divided into three categories: Sat #, Overview,
and Central Unit.
Sat #____
The information associated with the screens within this category is
stored in the satellite controllers and IS NOT stored in the MCD.
It is a very good idea to save this information on a back-up disk
by using the Satellite Save/Restore program located in the WCC
Utility Program.
Overview
This section allows the operator to perform operations and view
screens which affect all of the satellite controllers on the system.
MAIN MENU SCREEN
----------------------------------------------------------------------------------------------------------------------------------------------------------------------
08:11 1/20
WATTMASTER CONTROL CENTER III
WCC III
Sat #____ Overview Central Unit
Analog Input Alarm Summary PID Programs
Control Output Satellite Summary Week Schedules
Analog Output Overrides Optimal Starts
Trend Logs Holidays Analog Globals
Logic Switches System Parameters Binary Globals
Binary Output On/Off/Units Messages Shed/Restore Programs
Alarm Messages Duty Cycle Programs
Secure the System Proportional Programs
Energy Consumption Tenant Override
Custom Screens General Message
Bitmap Screens
Network Information
Active alarms in classes: 16
WCC III Version 2.21
BACKTASK Version 2.18 L
The information associated with the screens located in this
category is stored in the MCD. When the screens in this category
are programmed for the fi rst time, or when a change is made to
these screens, the system automatically stores the information on
the data disk.
Central Unit
The screens located in this category are GLOBAL commands.
Global commands “travel” along the two-wire communication
loop and are used by any or all of the satellite controllers. All of
the satellites are constantly monitoring this information but only
certain satellites will react to the information depending on how
they have been programmed. The information associated with the
screens located in this category is stored in the MCD. When the
screens in this category are programmed for the fi rst time or when
a change is made to these screens, the system automatically stores
the information on the hard drive disk.
Main Menu Screen