WattMaster WM-WCC3-TGD-01B - Manual (Page 56)

1. GENERAL INSTRUCTIONS
WCC III Technical Guide 1-2
Service Item As
Req’d
Every
Wk
Every
Mo
Every
3 Mo
Every
6 Mo
Every
12 Mo
Save satellite
data to disk X X
Test satellites’
local-set
capability X
Test satellites’
battery (or
capacitor) X
Check/Reset
trend logs X X
View/Clear all
alarms X X
Cycle power
to MCD to
verify correct
system re-start
after a power
outage X
* Set the screen’s intensity to the lowest setting when the system
is not being used.
WCC III Installation Software CD
Information
There are three available CD-ROMs available from WattMaster
Controls, Inc. - either from the factory or downloadable from the
wcc-controls.com website. They are as follows:
WattMaster Part # DM1WC011-01X*
This is the contractor installation CD for the main WCC III System.
This CD installs the following programs:
WCC3.EXE(SS5021), SCUSCR.EXE(SS5026),
WCCUTILITY.EXE(SS5023), TENANTOVERRIDE.
EXE(SS5024),TENANTREPORT.EXE(SS5025),
WCC3TRENDLOG.EXE(SS5028), WGCC3.
EXE(SS5029),WCC3DOWNLOAD.EXE(SS5030),
WCC3GUEST.EXE(SS5022).
WattMaster Part # DM1WC012-01X*
This is the end-user installation CD for “View Only” versions of
the WCC III system. This CD only installs the following programs:
WCC3GUEST.EXE(SS5022) and SCUSCRLtd.EXE(SS5027).
WattMaster Part # DM1WC013-01X*
This is the end-user installation CD for the Tenant Override
program. This CD only installs the following programs:
TENANTOVERRIDE.EXE(SS5024).
* = Where “X” is the software version A to Z.
WCC III Software Version List
The WCC III software is updated periodically to include more
features. The two fi les that change as the WCC III system is
upgraded are the WCC III fi le and the BACKTASK fi le. When
a WCC III fi le is installed in a system, the BACKTASK fi le may
need to be changed also. The Backtask software is located in the
MCD.
NOTE: You can see the present WCC III and BACKTASK
version used by the system by looking at the lower left hand
corner of the Main Menu Screen.
WCC III Software