WattMaster WM-WCC3-TGD-01B - Manual (Page 185)

WCC III Technical Guide 3-71
WCC3.EXE SCREEN DESCRIPTIONS
Satellite #: _____
Specifi es the number of the satellite you are currently editing.
If you would like to edit a different satellite, simply position the
cursor to this fi eld by using the cursor positioning (arrow) keys,
enter the desired satellite number, and press
.
Trend Log #: ____
This fi eld actually contains two separate fi elds. The fi rst fi eld
specifi es the point “type” (i.e., analog input, control output, analog
output, etc.) and displays the current type in textual form. Because
this is a “choice” fi eld, the list of available choices will be displayed
at the bottom of the screen:
TREND LOGGING, LOGIC SWITCH, BINARY OUTPUT>
Make your selection by pressing the once for each
choice until the desired point type has been selected and then
press
. (If you select a point type that is different than that
currently being displayed, the screen will be rewritten with the
appropriate screen and data.)
The second fi eld specifi es the point number to edit. For the Trend
Log Screen, this number can range from one to eight. If you would
like to edit a different point, simply position the cursor to this fi eld
by using the cursor positioning (arrow) keys, enter the desired
point number, and press
.
of Type
Specifi es which of the four available trend logging modes (analog
peak, analog trend, change-of-state, and run time) you wish to use.
Because this is a “choice” fi eld, the list of available choices will be
displayed at the bottom of the screen:
RUN TIME>
Make your selection by pressing the once for each
choice until the desired mode has been selected, and then press
. (When you select a trend logging mode that is different
than that currently being displayed, the screen will be rewritten
with the appropriate screen and data.)
Records total ____ time for: ______
Specifi es the state (ON or OFF) and the [binary] point address for
which the run time is to be recorded. Because the state fi eld is a
“choice” fi eld, the list of available choices will be displayed at the
bottom of the screen:
Make your selection by pressing the once for each
choice until the desired state has been selected, and then press
.
Satellite # 1 TREND LOGGING # 1 of Type: RUN TIME
Records total ON time Starting at : *:* on */*
for Klh S1-Kh Reset by: //// being ON
Alarm Type: 0
Alarm Message #: 0
Current run time: 1871 Hours Alarm Limit: 9999 Hours
HOME for menu
SAT RUN TIME TREND LOG SCREEN
SAT Run Time Trend Log Screen
Satellite Trend Log Summary Screen’s WCC III Logical Address is XXXTYr, where XXX = Satellite Address #, T = Trend Log, Y
= Point Number, r = Run Time