WattMaster WM-WCC3-TGD-01B - Manual (Page 638)

WCC III Technical Guide 13B-26
13B. WCC III - MCD INSTALLATION GUIDE
Copying fi le: /opt/backtask/Backtask/OperatorCode.dat
Copying fi le: /opt/backtask/Backtask/OptimalSchedule.dat
Copying fi le: /opt/backtask/Backtask/OverrideSchedule.dat
Copying fi le: /opt/backtask/Backtask/PidProgram.dat
Copying fi le: /opt/backtask/Backtask/ProportionalReset.dat
Copying fi le: /opt/backtask/Backtask/ShedRestoreSchedule.dat
Copying fi le: /opt/backtask/Backtask/StatusMessage.dat
Copying fi le: /opt/backtask/Backtask/SystemParameter.dat
Copying fi le: /opt/backtask/Backtask/table.dat
Copying fi le: /opt/backtask/TenantEvent_001_2009_09.dat
Copying fi le: /opt/backtask/TenantEvent_004_2009_10.dat
Copying fi le: /opt/backtask/TenantOverride.dat
Copying fi le: /opt/backtask/TenantOverrideRecord.dat
Copying fi le: /opt/backtask/UnitMessage.dat
Copying fi le: /opt/backtask/WeekSchedule.dat
Done copying .dat fi les.
Copying SlideFiles.
Done copying SlideFiles.
Copying WGGC fi les.
Done copying WGGC fi les.
Returning to Main Menu.
The screen should now take you back to the mcd-menu main
screen after about a second or two.
MCD-Menu Program
Copy the Backtask Data Files to USB
Drive (Choice #3)
This sub-program will copy all of the useful WCC III data fi les to
a USB drive (User / Contractor provided), assuming that there is
a USB drive plugged into any of the USB ports on the WCCIII-
MCD2. It will copy all of these fi les to the root of the USB drive.
This program assumes there is a USB fl ash drive inserted in the
bottom of the WCCIII-MCD2 even if it is not there. Therefore,
the program will not report that there is a drive reading or writing
error or any other errors. So when backing up the Backtask data
fi le, make sure that there is a USB fl ash drive in one of the USB
ports on the bottom of the WCCIII-MCD2. The LED on the USB
fl ash drive should light up when any data is written or read from
it. Please verify that this LED operates when backing up backtask
data to this USB fl ash drive.
All WCC III jobsites have multiple specifi c custom data fi les that
are the responsibility of the end user and/or mechanical contractor.
Any loss or the actual retention of these jobsite specifi c custom
data fi les are not within WattMaster Controls, Inc. liabilities.
The following will be displayed on the screen:
Selecting Copy Backtask Files to USB Drive.
Copying fi le: /opt/backtask/AlarmBits.dat
Copying fi le: /opt/backtask/AlarmMessage.dat
Copying fi le: /opt/backtask/EnergyConsumption.dat
Copying fi le: /opt/backtask/GeneralMessage.dat
Copying fi le: /opt/backtask/GlobalAnalog.dat
Copying fi le: /opt/backtask/GlobalBinary.dat
Copying fi le: /opt/backtask/HolidaySchedule.dat
Copying fi le: /opt/backtask/LookUpTable.dat
Copying fi le: /opt/backtask/Backtask/NetworkInformation.dat