WattMaster WM-WCC3-TGD-01B - Manual (Page 643)

13B. WCC III - MCD2 INSTALLATION GUIDE
WCC III Technical Guide 13B-31
Restart LCD Display (Choice #14)
On the front of the WCCIII-MCD2, there is a 4 by 20 line LCD
display. This display will display the following information:
WCCIII – MCD IP ADDRESS
WCCIII – MCD TIME AND DATE
WCCIII – MCD UPTIME
WCCIII – MCD IP RECEIVE AND TRANSMIT PACKETS
WCCIII – MCD CPU UTILIZATION
This will stop the LCD display program and then restart it. The
reasons why you might want to restart the 4 by 20 line LCD display
are: (1) there may have been an issue with a stuck or blanked out
screen, or (2) the USB connection to the 4 by 20 line LCD display
might have been disconnected or locked up.
If you have selected to restart the LCD display, the following will
be displayed on the screen:
Selecting Restart LCD Display.
Restarting LCD Display...
* Restarting backtask-lcd v1.00 display driver for MCD2
backtask-lcd [OK]
The screen should now take you back to the mcd-menu main
screen after about a second or two.
Shutdown MCD (Choice #15)
There are times that occur when you would need to shut down
the WCCIII-MCD2. This is generally done when servicing
the WCCIII-MCD2 or when you have software updates to the
WCCIII-MCD2.
If you have selected to shut down the MCD2, the following will be
displayed on the screen:
*************************************************
* Shutdown MCD *
* *
******************************************
Broadcast message from wcciii@wcciii-mcd
(/dev/pts/0) at 9:01 ...
The system is going down for halt in 3 minutes!
You may cancel this shutdown command with a “Ctrl” “C”
key sequence anytime during this 3 minute shutdown time. The
following shutdown canceled confi rming message will display:
shutdown: Shutdown canceled
MCD-Menu Program
Shutdown and Reboot the MCD
(Choice #16)
This is an immediate shutdown and reboot of the WCCIII-MCD2.
You may not cancel this shutdown command with a “Ctrl” “C”
key sequence.
There are times that occur when you would need to shut down
and then restart the WCCIII-MCD2. This is generally done when
servicing the WCCIII-MCD2, or when you have software updates
to the WCCIII-MCD2.
If you have selected to shut down the MCD, the following will be
displayed on the screen:
*************************************************
* Shutdown and Reboot MCD *
* *
******************************************
Broadcast message from wcciii@wcciii-mcd
(/dev/pts/0) at 9:01 ...11
The system is going down for reboot NOW!