Wall mounting of the wcc iii - mcd – WattMaster WM-WCC3-TGD-01B User Manual
Page 499
12. WCC III INSTALLATION
GUIDE
WCC III Technical Guide
12-3
Figure 12-2: Wall mounting instructions for the WCC III – MCD
NOTES:
Use approved anchors when mounting backer plate board on a concrete wall. If mounting backer plate board to dry wall, use
at least 2-inch dry wall type screws. Mount the backer plate board so that the screws that are holding the backer plate board are on the 16-
inch centers of the wall where applicable.
Mount the WCC III - MCD 4-½ to 5-½ feet off of the ground on a suitable wall in an air conditioned space. This space should not have any
radio transmitting or telephone switching gear in the space, or near the space, or located on the back-side of the adjacent wall.
Do not block the airfl ow vents that are coming out of the WCC III - MCD. Do not apply paint to the WCC III - MCD enclosure. Do not
cover the WCC III - MCD with any protective plastic while painting with the WCC III - MCD turned on.
The UPS should be located within 3 or 4 feet of this WCC III - MCD.
Wall Mounting of the WCC III - MCD
Front view with wall mounting brackets
Use 3/4 inch plywood for the backer plate board
(supplied by others)
Wall Mounting of the WCC III - MCD