WattMaster WM-WCC3-TGD-01B - Manual (Page 838)

Logic Switch Summary Screen
Figure 20: Logic Switch Summary Screen
The Logic Switch Screen must also be fi lled out in order for the
Binary points to be used externally from the TUC within the WCC III
system.
Description:
On the Logic Switch Screen you may want to fi ll in the description fi eld
with a short message for each binary point to help you remember points
within the system. You may enter up to twelve characters (control codes,
ALT codes, and the double quote character are not allowed).
On/Off Messages:
A number is entered here that references a message on the On/Off Units
Messages Screen . For example, if units-of-measure message #1 is
“On”, entering “1” for the “On Message:” will cause “On” to be displayed
as the “Current” message for the binary input anytime it is on.
Confi g:
This is a choice fi eld for the Confi guration type. A list of available choices
will be displayed at the bottom of the screen:
< On Board, Off Board >
For the Sat 3F, the only Confi guration used will be “On Board”. You may
make your selection by
pressing the until “On Board”
has been selected and then pressing .
Time Delay:
This function is not used for the SAT 3F and should be set to 0 (zero).
34 VAV/Zone Controller Actuator Package Technical Guide
Programming a SAT 3F