Toshiba Magnia 3030 - Manual (Page 98)

Installing and Removing Hardware
SCSI Device 80
1 If the server is running, shut it down and turn off the power.
2 For the EPS model, unplug the power cable.
3 For the EPS-R model, set the DC operate switch on the back of the server to
OFF and then unplug the power cable.
NOTE: Installing the SCSI device while the power is on may damage the
server and SCSI device.
4 Remove the server panels.
See “Removing and replacing the server panels” on page 24.
5 Remove the device bay spacer.
See “Removing the Device Bay Spacer” on page 79.
6 Remove the rails installed in the device bay spacer.
Removing the rails of device bay spacer
7 Install the removed rails in the SCSI device to be extended and fix them
with two screws.