Toshiba Magnia 3030 - Manual (Page 61)

Getting Started
BIOS Setup
43
BIOS Setup
Initial system setting on shipment can be changed by the BIOS setup menu.
The BIOS setup can be performed regardless of presence or absence of the
operating system. Values entered by the BIOS setup are written in the CMOS
and the flash memory, and reset values come into effect when the server is
restarted. Those values are used as the reference for execution of the POST.
If the entered values and actual hardware don’t correspond to each other, error
message appears after the POST is complete. If this error occurs, change the
setting by executing setup operation. For changing the setup, use the BIOS
Setup Utility or the System Setup Utility (SSU).
Making Floppy Disks
The server setup support software “Toshiba Server Setup Tool” has the function
to make backup floppy disks of data on the driver, utilities and so on used in this
system. Make backup floppy disks depending on the situation, and carefully
keep them for future use.
How to make a backup floppy disk
For making a backup floppy disk with the “Toshiba Server Setup Tool”, follow
the procedure mentioned below referring to the instructions appearing on the
display for details.
1 Set both the “Toshiba Server Setup Tool CD-ROM” and “Startup Disk
floppy disk” in the respective drives, and start the “Toshiba Server Setup
Tool”.
2 Select “Utility”.
3 Select “Making FD”.
4 Select the name of the floppy disk to make and then select “OK”.
5 Set a 1.44MB formatted floppy disk in the disk drive and then select “OK”.
If the “Startup Disk” is set in the drive, remove it before setting a floppy
disk.
For details of making a floppy disk:
See “Toshiba Server Setup Tool User’s Guide”