Toshiba Magnia 3030 - Manual (Page 100)

Installing and Removing Hardware
SCSI Device 82
Connecting the cables
9 Push the device in firmly until the latches click into place.
Inserting the SCSI device
10 Install the server panels.
11 Connect the power cable and turn on the power of the server.
For the EPS-R model, set the DC operate switch to ON and then turn on the
power.
Removing the SCSI Device
Remove the SCSI device in the procedure below referring to “Before starting
operation” in Chapter 2.
1 If the server is running, shut it down and turn off the power.
2 For the EPS model, unplug the power cable.