Toshiba Magnia 3030 - Manual (Page 116)

Installing and Removing Hardware
Expansion Cards 98
Installing the RAID controller
NOTE: Be careful not to damage other cables. Install the RAID controller hor-
izontally so that it is not caught on the hooks above and below the slot.
8 Connect a SCSI cable to the SCSI connector of the RAID controller.
Connecting the SCSI cable
Connect the SCSI cable to channel 1 when using the RAID card that has
two internal magnetic disk connectors.
See the Instruction Manual of RAID controller
9 Install the server panels.
10 Connect the power cable and turn on the power of the server.
For the EPS-R model, set the DC operate switch to ON and turn on the
power.
To set up the disk array (RAID) and install the software
See the Instruction Manual of RAID controller