Toshiba Magnia 3030 - Manual (Page 44)

Getting Started
Removing and replacing the server panels 26
Removing the top panel (for rack models)
Follow these steps to remove the top panel.
1 Shut down the server and turn off the power switch if it is in operation.
2 If your server is an EPS model, unplug the power cable.
3 If your server is an EPS-R model, turn off the DC operate switch on the
back of the server, and then unplug the power cable.
4 Unplug the display cable, keyboard cable, etc., as appropriate.
5 Remove the 2 thumbscrews.
6 Hold the handles on both side and slowly pull the server toward you until it
comes into contact with the stopper.
Pulling out the server (rack model)
7 Make sure that the stopper is caught by the rack rail and the server cannot be
pushed back any more.
8 Turn the side panel lock key to the vertical position to release the lock.
9 Slide the top panel by about 0.5 inches (1 cm) toward the rear of the server
to remove it from the server.
Replacing the side panel (for pedestal models)
Follow these steps to replace the side panel.
1 Replace the side panel to the server carefully so that it does not catch any
cable.
2 Turn the side panel lock key to the vertical position to lock the side panel.
3 Make sure all the panels are locked, then close the front doors.
4 Plug the power cable.