Toshiba Magnia 3030 - Manual (Page 113)

Installing and Removing Hardware
Expansion Cards
95
Raising the card support
6 Install the expansion card in the slot that satisfies the conditions of slot
restriction and fix it using the card support.
Install the expansion card horizontally so that it is not caught on the hooks
above and below the slot.
If you are difficult to push down the expansion card support, raise the
expansion card support higher than it by one stage and then push down.
Installing the expansion card
7 Install the server panels.
8 Connect the power cable and turn on the power of the server.
For the EPS-R model, set the DC operate switch to ON and then turn on the
power.
NOTE: The settings of the jumper switches on the expansion card and DIP
switches may have to be changed. Some expansion cards also need to be
set up using the system setup utility (SSU).