Toshiba Magnia 3030 - Manual (Page 65)

Getting Started
Switching Off the Server
47
Switching Off the Server
The method to switch off the server varies depending on the operating system
used. Depending on the operating system switch off the server by the normal
method or the automatic shutdown function.
Be sure to use only one method of the two mentioned above every time. If the
two methods are mixed, the server may fail in the normal shutdown operation.
Normal shutdown
If no automatic shutdown function is installed in the operating system, switch
off the server by the normal shutdown method according to the following
procedure.
1 Prepare the server system for switching it off by the normal method.
Method to shut down the operating system
See “Instructions of the operating system”
2 Press the power switch.
Hold the power switch pressed until the Auto SD/remote indicator lamp
(
) starts blinking and the intermittent buzzer sound changes into a
continuous sound. It takes about 4 seconds that the intermittent buzzer
sound changes into the continuous sound. If the power switch is released
from depressing before the intermittent sound changes into the continuous
sound, the shutdown operation is disturbed in the middle of the process and
the server resultingly fails in shutdown.
NOTE: If the server is switched on by the Wake On LAN function once and it is
switched off before loading of the LAN driver on the Windows NT, the Wake
On LAN function may fail in switching on the server next time. If this trouble
occurs, disconnect the power cable from the AC outlet once, and then supply
the power to the server again.
Off