Toshiba Magnia 3030 - Manual (Page 27)

Getting Started
Front view (with the front doors opened)
9
™ Eject button (button on the right side)
Used to slide the disk tray in or out of the CD-ROM drive.
NOTE: The button on the left side is inoperative with this system.
™ Eject hole
Used to forcefully eject the disk tray if it does not slide out while you press
the eject button. Insert a fine wire (e.g., straightened paper clip) into this
hole to forcefully eject the tray.
NOTE: Be sure to turn off the server before forcefully ejecting the CD-ROM.
Do not insert any fragile pin, such as a mechanical pencil lead or a plastic pin.
Do not press the eject button when the CD-ROM drive status indicator is lit.
Otherwise, the CD-ROM drive might fail.
After using the CD-ROM drive, always remove the CD-ROM from it.
The disk trays of some CD-ROM drives are provided with disk holders. Do not
use the disk holder along with this system, except when the system is used as
a rack model.
Disk tray
Precautions in handling a CD-ROM
Take the following precautions when handling a CD-ROM.
™ Hold the center and circumference edge of the CD-ROM carefully so as not
to touch its recorded surface.