Toshiba Magnia 3030 - Manual (Page 86)

Installing and Removing Hardware
CPU Module 68
Install the CPU module in the procedure below referring to “Before starting
operation” in Chapter 2.
1 If the server is running, shut it down and turn off the power.
2 For the EPS model, unplug the power cable.
3 For the EPS-R model, set the DC operate switch on the back of the server to
OFF and then unplug the power cable.
NOTE: Installing the CPU module while the power is on could cause damage
to the server or the memory module.
4 Remove the server panels.
See “Removing and replacing the server panels” on page 24.
CAUTION: Do not extend or replace the CPU module immediately after the
power is turned off. This may cause burns because CPU generates heat in its
periphery.
5 Remove the two screws fixing the fan duct and then remove the fan duct.
See “Cooling Fan” on page 58.
6 Push the lock levers of the termination board support inwards, installed in
an extension CPU slot.
Moving the lock levers
7 Pull out the termination board.