Toshiba Magnia 3030 - Manual (Page 211)

Troubleshooting
Types of Trouble and Their Solutions
193
Refer to the display unit operating manual
™ Are the signal cable and power cord of the display unit connected prop-
erly?
™ When Windows NT is used, are the current resolution and synchroniz-
ing frequency supported by the display unit? Start the server in VGA
mode to check for normal operation.
The FDD lamp does not light up
™ Are the signal cable and power cord of the floppy disk drive connected
properly?
™ Is the floppy disk drive set properly?
The HDD status indicators do not light up
™ Is the SCSI cable connected properly to the SCSI controller?
™ Is the magnetic disk unit mounted properly?
™ If you are using RAID controllers, is the RAID configuration set cor-
rectly?
The magnetic disk unit does not respond
Trouble could result if the SCSI controller of a third party fails to send the
‘start unit’ command during the startup of the SCSI ROM. When loading
the ROM, modify defined SCSI BIOS data so that all magnetic disk units
start operating properly.
The above modification is required for all Adaptec controllers.
Refer to the RAID controller operating manual for SCSI BIOS setting