Toshiba Magnia 3030 - Manual (Page 153)

System Configuration Setup
BIOS Setup Utility
135
™ BaseI/O address : 3F8
Set the I/O port address for serial port 1.
™ Interrupt : IRQ4
Set the interrupt level for the serial port1.
→ (On-Board Communications Devices Group)
Serial Port 1 Configuration
COM2 : Enabled
™ Base I/O address : 2F8
Set the I/O port address for serial port 2.
™ Interrupt : IRQ3
Set the interrupt level for serial port 2.
→ (On-Board Communications Devices Group)
Serial Port2 Configuration
Parallel port : Enabled
™ Mode : Output Only
Set the operation mode for the serial port; select “Output Only”.
™ Base I/O Address : 378
Set the I/O port address for the parallel port.
™ Interrupt : IRQ7
Set the interrupt level for the parallel port.
→ (On-Board Communications Devices Group)
Parallel Port Configuration/Parallel Port Mode
Floppy disk controller : Enabled
Set whether the built-in floppy disk controller is to be enabled or disabled;
select “Enabled”.
→ (On-Board Disk controllers Group)
On-Board Floppy Controller
™ Advanced Chipset Control
Do not change the setting.
™ Use Multiprocessor Specification : 1.4
Set data on the multi-processor specifications; select “1.4”.