Toshiba Magnia 3030 - Manual (Page 73)

Installing and Removing Hardware
Installing and Removing Optional Devices
55
Screw head and screwdriver
NOTE: Some optional devices need to remove the cable and the like for
installing and removing them. In this case, check the relative position between
the unit and cables before disconnecting the cables for reference to avoid
making a mistake in connecting them again.
When connecting a cable to the server, pay careful attention to the shape of
the connector. If a wrong connector is forcibly connected, it may bend or
damage the connector pins. If the cable connector has thumb screws for fas-
tening, tighten them to secure the connection.
Carefully handle options whose boards are not covered such as expansion
cards and so on because they are easily affected by static electricity. When
holding an option whose board is exposed, hold it by the part other than the
edge (gold-plated part) without touching any component part.
After taking a device out of the antistatic package, put it horizontally with the
components side up on a grounded plane free from static electricity. After tak-
ing out a device, keep the antistatic packing case for future use. Don’t slide
the server for relocation.
The user is not permitted to remove the server from the rack. If it is hard to
install/remove an optional device as the server is mounted on the rack, ask an
authorized Magnia service provider to do the work (A service fee is charged
for).
Special knowledge and technique are required for installing an optional device
to the server of the rack model. If you have no experience in installing an
option to the rack model or you consider the job difficult, consult with an
authorized Magnia service provider about installation (A service fee is charged
for).