Selecting the onboard network adapter driver – Toshiba Magnia 3030 User Manual

Page 184

Installing Software
Installing the NetWare 5

166

4 Press the key to designate the directory of the floppy disk as follows.

A: \NetWare\NW5

As the driver is detected, it is added to the “List of drivers currently
selected” as shown below..

5 Set the floppy disk labeled “7800 Family Manager Set Novell NetWare

3.1x/Novell NetWare 4.xx” (created by Toshiba Server Setup Tool) in the
floppy disk drive, and press the key twice to select the “0DAdd an
unlisted driver ”.

When the Onboard SCSI is not used, the steps 5 and 6 are not required.

6 Press the key to retrieve drivers contained in the floppy disk.

The drivers contained in the floppy disk are added to the “List of drivers
currently selected” as shown below.
(Since the Onboard SCSI Controller has two channels, the two drivers are
selected.))

7 Proceed with installation operation following the instructions that appear on

the screen.

Selecting the Onboard Network Adapter driver

When the installer detects the network adapter, the following screen appears.

Select “Modify” to replace the driver.

|| MEGA4_XX.HAM || AMI MegaRAID XXX Adapter

|| AIC78U2.HAM ||