Toshiba Magnia 3030 - Manual (Page 82)

Installing and Removing Hardware
Memory Module 64
1 If the server is in operation, shut it down first and cut off the power supply to
it.
2 For the EPS model, unplug the power cable from the AC outlet.
3 For the EPS-R model, turn off the DC operate switch on the back of the
server first and then unplug the power cable from the AC outlet.
NOTE: Installing a memory module while the server is still energized could
cause damage to the server or the memory module.
4 Remove the panels from the server.
See “Removing and replacing the server panels” on page 24.
5 Remove the two screws fixing the fan duct and then remove the fan duct.
See “Cooling Fan” on page 58.
6 Extend the hooks on both sides of the memory slot outwards and remove
the memory slot cover.
Removing the memory slot cover
7 Insert the memory module into the proper memory slot paying heed to the
position of each notch on the memory module.
Insert the memory module until it is locked by the hooks on both sides.