Toshiba Magnia 3030 - Manual (Page 110)

Installing and Removing Hardware
Expansion Cards 92
Expansion Cards
Up to 1 ISA and 6 PCI expansion cards can be installed in the server.
Expansion slots
Restrictions on ISA expansion cards
An ISA expansion cards requiring a power supply of -5 V cannot be used
because -5 V is not supplied to the ISA slot.
Restrictions on PCI expansion cards
In some cases, a memory module cannot be replaced because of interference
with an optional card in a PCI slot (PCI-6). In such a case, remove the optional
card, then replace the memory module.
Setting of IRQ
Set the optimum IRQ level using a system setup utility (SSU) referring to the
standard interrupt level (IRQ) described in “Appendix A: Interrupt levels” on
page 200.
See “SSU (System Setup Utility)” on page 105.”
See the Instruction Manual of each expansion cards
The contents of setting must be considered for the setting when you install
other devices. Therefore, Toshiba recommends that you record the setting in
Appendix D Device Log.
Cautions when Adding RAID Controllers and SCSI Host Adapters
The server’s system BIOS is compliant to the BIOS Boot Specification (BBS).
By combining the system BIOS with a BBS-compatible RAID controller or
SCSI host adapter, you can select the hard disk drive that will boot the OS
PCI-6
PCI-5
PCI-4
PCI-3
PCI-2
PCI-1
ISA-1