Toshiba Magnia 3030 - Manual (Page 158)

System Configuration Setup
BIOS Setup Utility 140
Set whether the detection of a PCI bus system error (SERR signal: SERR)
is to be enabled or disabled.
Boot menu
All are recommended settings.
Set the sequence in which the operating system is to be booted for devices. Do
not change the setting.
™ Boot-time Diagnostic Screen : Enabled
Set whether the POST screen mode is to be made valid or not (“Enabled” or
“Disabled”) during the boot. Do not change the setting.
™ Exended RAM Step : Every Location
Set the capacity of the memory to be tested during the boot. Do not change
the setting.
™ BIOS Boot Spec Support : Enabled
Select whether BBS is to be supported or not (“Enabled” or “Disabled”).
™ Boot Device Priority
Select the device for which the operating system is to be booted.
“LANDesk Service Agent II” is invalid for the system.
™ Hard Drive
Select the hard disk drive for which the operating system is to be booted per
BBS.
™ Removable Devices
Set the operating system boot sequence for the floppy disk drive and other
devices that can be removed.
Boot-time Diagnostic Screen [Enabled]
Extended RAM Step [Every Location]
>BIOS Boot Spec Support [Enabled]
>Boot Device Priority
>Hard Drive
>Removable Devices