Toshiba Magnia 3030 - Manual (Page 23)

Getting Started
Power requirements
5
Power requirements
The EPS and EPS-R cages of this system have 6.3 A and 10 A over-current
protective circuits, respectively.
Before plugging the power cable to a wall outlet, especially if your server is a
rack model, make sure of the capacity of the power supply (current rating of the
wall outlet) and that of the over-current protector (current rating of the circuit
breaker).
Whenever you have a question about wiring etc., consult an authorized Magnia
service provider.
The server has a current rating of either 3.6 A (EPS models) or
4.0 A (EPS-R models).
To ground the server securely, always use the supplied power cable.
For wiring in the rack, use an optional AC multi-tap recommended by Toshiba.
WARNING: Do not use any power cable other than the supplied one.
The use of an improper power cable might result in a fire.
Do not use any optional part other than the Toshiba genuine parts or parts
recommended by Toshiba.
The use of a part other than the Toshiba genuine or recommended parts
might result in a fire. For optionally-available parts and devices, contact an
authorized Magnia service provider.
NOTE: For both pedestal and rack models, it is recommended to use an
uninterruptive power supply (UPS).