Toshiba Magnia 3030 - Manual (Page 171)

System Configuration Setup
Disk array (RAID) setting
153
™ SCSI Channel - Ultra SCSI
This option sets the SCSI bus in either “Ultra SCSI” mode or “Fast SCSI”
mode. Selection of “Enabled” makes the setting of the SCSI bus in “Ultra
SCSI” mode valid. Select “Disabled” if an extended disk unit is connected
to the SCSI bus.
™ Adapter - Factory Defaults
Execution of this option resets all setup items, except the following, to
defaults:
™ Degraded Mode Bootup
The parameters, such as Write Policy and Read Policy, that are written under
“Logical drive, View/Update Parameters”
NOTE: Set the RAID cache to “Write-back”. Use “Write-through” mode to
set the cache, and use “Write-back” mode to operate the cache.
Option Defined value
Object – Adapter :
– FlexRAID Powerfail Enabled
– Disk Spin up Timings Automatic Spinup
– Chip Set Type Other
– Cache Flush Timings Every 4 Seconds
– Rebuild Rate 50%
– Alarm Control Enable Alarm
– Auto Rebuild Disabled
Objects – Physical Drive :
– Synchronous Negotiation Enable Synchronous Negotiation
– SCSI – 2 Command Tagging Enhanced Qtag Shceduling