Toshiba Magnia 3030 - Manual (Page 181)

Installing Software
NetWare
163
6 After creating the floppy disk, open the “Creating FDs” by selecting it from
the “Utilities” menu and verify the contents of the FD label, and then label
the floppy disk.
FD label:DOS Disk
FD label:7800 Family Manager Set
Novell NetWare3.1x/Novell NetWare4.xx
FD label:Intel EtherExpress PRO/100+LAN Adapter Configuration and
Drivers Diskette NetWare
Setup of the MS-DOS environment
The environment to install the NetWare can be set up in the three ways of the
following.
1 Install the MS-DOS by use of the Toshiba Server Setup Tool so that the
installing 0Denvironment for the NetWare is automatically set up. After the
MS-DOS is installed by the Toshiba Server Setup Tool, the environment to
read the CD-ROM of the NetWare is automatically set up.0D
See “Toshiba Server Setup Tool User’s Guide” for installing the MS-DOS
by the Toshiba Server Setup Tool
2 Create DOS disk by the “Creating FDs” of the Toshiba Server Setup Tool,
and manually set up the partition to activate the NetWare on the MS-DOS.
3 Install the MS-DOS and set up the MS-DOS environment manually.
Condition of the MS-DOS environment for installing the NetWare
In the case the MS-DOS is manually installed, the MS-DOS environment for
installing the NetWare must be set up in the following condition.
1 The extended memory has been removed.
To remove the extended memory, invalidate the lines containing the follow-
ing texts in the “Config.sys” and “Autoexec.bat” by the REM statement.
In “Config.sys”
HIMEM.SYS
HIGH
EMM386.EXE
In “Autoexec.bat”
SMARTDRV.EXE
2 The CD-ROM drive is recognized on the MS-DOS.
To make the MS-DOS recognize the CD-ROM drive, set up the MS-DOS
environment as mentioned in the preceding step (1) and set the floppy disk