Toshiba Magnia 3030 - Manual (Page 187)

Installing Software
Installing the NetWare 5
169
3 Press the key to retrieve drivers contained in the floppy disk.
4 When the driver list appears, select the following driver.
5 Select the Onboard SCSI Controller driver once more in the same manner
as mentioned above, because the Onboard SCSI Controller has two chan-
nels.
6 Proceed with installing operation following the instructions that appear on
the screen.
NOTE: Selection of the slot numbers (10002 and 10003 in usual) is shown
by the System Console.
The number appearing first represents the slot that is connected with the
internal magnetic disk drive while the number appearing second represents
the slot for connecting a 5.25” disk device. Those numbers vary depending
on the system configuration.
Selecting the RAID Controller driver
Operate following the procedure mentioned below.
1 After selecting the driver following the procedure of the previous section
“Selecting the Onboard SCSI Controller driver”, select “Select an additional
driver”.
2 Set the floppy disk labeled “MegaRAID Drivers & Utilities for SeriesXXX
NetWare/MS-DOS” (supplied with the RAID Controller) in the floppy disk
drive.
3 Select “Install an unlisted driver ” by pressing the key.
4 Press the key to input the directory “A:\NetWare\NW4” contained in
the floppy disk.
5 Press the key to retrieve drivers contained in the floppy disk.
6 When the driver list appears, select the following driver.
7 Proceed with installing operation following the instructions that appear on
the screen.
|| AIC78U2.HAM ||Adaptec AIC-7890 ASPI & SCSI Module
|| MEGA4_XX.HAM ||Netware 4.x NPA Ham Driver for MegaRAID ||