Toshiba Magnia 3030 - Manual (Page 174)

Installing Software
Windows NT Server 4.0 156
FD label:Intel EtherExpress PRO/100+LAN Adapter
Configuration and Drivers Diskette WindowsNT
Selecting the disk driver
Selecting the IDE CD-ROM Controller driver
Operate following the procedure mentioned below.
1 If a message asking you a question to detect or not to detect the mass stor-
age device appears during setup of the Windows NT Server 4.0 (in the pro-
cess of the second Setup floppy disk), select “S=Skip Detection”.
2 Select “S=Specify Additional Device”, and then select “IDE CD-ROM
(ATAPI1_2)/PCI IDE Controller”.
Selecting the Onboard SCSI Controller driver
Operate following the procedure mentioned below.
1 If a message asking you a question to detect or not to detect the mass stor-
age device appears during setup of the Windows NT Server 4.0 (in the pro-
cess of the second Setup floppy disk), select “S=Skip Detection”.
2 Select “S=Specify Additional Device”, and then select “Other (Requires
disk provided by a hardware manufacturer)”.
3 Set the floppy disk labeled “7800 Family Manager Set Microsoft Windows
NT, Microsoft Windows 95/98” (created by the Toshiba Server Setup Tool)
in the floppy disk drive, and press the key.
4 As the following menu screen appears, select “AdaptecAHA294xU2/
295xU2/395xU2/AIC-789x PCI SCSI Controller(NT4.0)” from it
Selecting the RAID Controller driver
Operate following the procedure mentioned below.
1 After selecting the Onboard SCSI Controller driver by the “Selecting the
Onboard SCSI Controller driver” mentioned previously, select “S=Specify
Additional Device”.
2 Select “Other (Requires disk provided by a hardware manufacturer)”.
IDE CD-ROM (ATAPI1_2/PCI IDE Controller
AdaptecAHA290x/291x/294x/394x/4944/AIC-78xx PCI SCSI Controller(NT3.5X)
AdaptecAHA290x/291x/294x/394x/4944/AIC-78xx PCI SCSI Controller(NT4.0)
AdaptecAHA294xU2/395xU2/AIC-789x PCI SCSI Controller(NT3.5X)
AdaptecAHA294xU2/395xU2/AIC-789x PCI SCSI Controller(NT4.0)