Toshiba Magnia 3030 - Manual (Page 88)

Installing and Removing Hardware
CPU Module 70
Moving the CPU guide rail slider
NOTE: Do not push the heat sink section of the CPU module. This may cause
the deformation of the heat sink.
Push the CPU module until both ends of it become uniformly horizontal on the
right and left and confirm that it was inserted completely.
10 Install the fan duct and tighten the screws.
Installing the fan duct
11 Install the server panels.
12 Connect the power cable and turn on the power of the server.
For the EPS-R model, set the DC operate switch to ON and then turn on the
power.
13 Press the key during activation to start the BIOS setup utility and
change the “Processor Retest” set value in a server menu to “Yes”.
14 Save the changed value and restart.
15 Confirm that the CPU module is recognized properly with the display on
the screen.
If it is properly recognized, the same information on CPU is displayed in