Toshiba Magnia 3030 - Manual (Page 175)

Installing Software
Windows NT Server 4.0
157
3 Set the floppy disk labeled “MegaRAID Drivers & Utilities Windows NT/
Power Console” (supplied with the RAID Controller) in the floppy disk
drive, and press the key.
4 As the following menu appears, select “MEGARAID NT SCSI Driver”
from it..
5 Proceed to further steps following the installing instructions that appear on
the screen.
NOTE: If the RAID Controller is connected with the server, be sure to install
the “Power Console” of the RAID Controller Utility after installation of the
Windows NT Server 4.0.
See “RAID Controller User’s Guide” for details of the Power Console
Selecting the Onboard Network Adapter driver
Operate following the procedure mentioned below.
1 If a message “Remote Access to the Network” or “Wired to the Network”
appears on the “Installing WindowsNT Networking” menu of the “Win-
dows NT Setup”, select “Wired to the Network” and then select “next”.
2 Select “Select from list” from the driver selection menu and select “Have
Disk” from the submenu.
3 Set the floppy disk labeled “Intel EtherExpress PRO/100+ LAN Adapter
Configuration and Driver Diskette WindowsNT” (created by the Toshiba
Server Setup Tool) in the floppy disk drive, and press the key.
4 Select “Intel (R) PRO Adapter” from the following menu appearing on the
display.
5 Proceed to further steps following the installing instructions that appear on
the display.
MEGARAID NT SCSI Driver
Intel(R)PRO Adapter