Toshiba Magnia 3030 User Manual

Page 101

Installing and Removing Hardware

SCSI Device

3 For the EPS-R model, set the DC operate switch on the back of the server to

OFF and then unplug the power cable.

NOTE: Removing the SCSI device while the power is on may damage the
server and SCSI device.

4 Remove the server panels.

See “Removing and replacing the server panels” on page 24.

5 Put your fingers on both sides of the SCSI device and pull out it slightly

toward you while pushing the hooks.

6 Remove the power and signal cables.

Removing the cables

7 Pull out the SCSI device completely.

8 Install the device bay spacer.

9 Install the server panels.

10 Connect the power cable and turn on the power of the server.

For the EPS-R model, set the DC operate switch to ON and turn on the
power.

NOTE: Use only SCSI devices that Toshiba recommends. Other devices may
not be installable due to differences in dimensions and shape or may cause
an unstable operation or trouble. Toshiba assumes no responsibility for
devices not specifically recommended.

For the setting of an on-board SCSI controller
See “Onboard SCSI Utility” on page 142.