Toshiba Magnia 3030 - Manual (Page 83)

Installing and Removing Hardware
Memory Module
65
Installing a memory module
8 Install the fan duct and tighten the screws.
See “Cooling Fan” on page 58.
9 Fit the panels to the server.
10 Connect the power cable of the server to the AC outlet and switch on the
server.
For the EPS-R model, switch on the server after turning on the DC operate
switch.
NOTE: Don’t hold a memory module by the part of the connecting terminal. If
the part of the connecting terminal is touched by hand, it may cause the
memory module to be poor in contact.
Be careful not to insert an extension memory module in a wrong orientation.
Wrong installation of a memory module may cause damage to the memory
module or the memory slot.
Removing a memory module
Before starting the job to remove a memory module, carefully read “Before
starting operation” of this chapter and proceed to the job following the proce-
dure mentioned below.