Toshiba Magnia 3030 User Manual

Page 60

Getting Started
Starting Up the System

Starting up by the hard disk drive unit (in the case the OS has been
installed)

For starting up the server by the hard disk drive unit, follow the procedure
mentioned below.

1 Make sure that neither floppy disk nor CD-ROM that is capable of starting

up the server is not set in each drive unit.

2 Turn on the power switch.

NOTE: The CD-ROM can be ejected from the CD-ROM drive unit only when
the system is turned on. Remove the CD-ROM from the drive unit before
turning off the system without fail.
When you doubt whether there is a CD-ROM set in the drive unit or not, you
can check it by pressing the eject button of the CD-ROM drive unit while the
power-on self test is being performed after the power switch is turned on.
If the CD-ROM for starting up the server is set in the CD-ROM drive unit,
startup operation by the hard disk drive unit results in failure even if the CD-
ROM is ejected after the system is turned on.

Starting up by the CD-ROM drive unit

For starting up the server by the CD-ROM drive unit, follow the procedure
mentioned below.

1 Make sure that no floppy disk is set in the disk drive.

2 Turn on the power switch.

3 Immediately after turning on the power switch, press the eject button of the

CD-ROM drive unit and set the CD-ROM capable of starting up the server
in the drive.

NOTE: The CD-ROM can be ejected from the CD-ROM drive unit only when
the system is turned on. For starting up the server by the CD-ROM drive unit,
it is required to set the startup CD-ROM in the drive before the Onboard SCSI
Controller BIOS setup menu appears as a series of the POST screen after the
power switch is turned on.
If the startup CD-ROM is set in the drive too late, restart up the server by
pressing the ++ keys together.
After startup, once the CD-ROM is recognized, the hard disk drive is disabled
from starting up the server even if the CD-ROM is ejected.