Toshiba Magnia 3030 - Manual (Page 180)

Installing Software
NetWare 162
NetWare
Before installing the NetWare
If the Toshiba Server Setup Tool is used, it automatically carries out setup of the
system configuration and disk array (RAID) as well as installation of the MS-
DOS. In other words, the Toshiba Server Setup Tool automatically prepares the
installing environment for the NetWare.
On the other hand, an MS-DOS disk can be created by use of the Toshiba
Server Setup Tool so that the MS-DOS environment can be set up manually
without use of the DOS Installer of the Toshiba Server Setup Tool.
Setup of the mother board
Activate the BIOS Setup Utility and select “Disabled” for “PCI IRQ to IO-
APIC Mapping” appearing in the lower part of the “Server” menu. If
“Enabled” is selected for “PCI IRQ to IO-APIC Mapping”, interrupt process-
ing on the NetWare may fail in normal operation.
Setting of the function of the “Automatic SD/Remote” indicator lamp.
The automatic shutdown function cannot be used on the NetWare. If the server
is used with the initial setting, the “Automatic SD/Remote” indicator lamp
lights in orange whenever the server is turned on.
Preparation of a floppy disk
For installing the NetWare, it is required to create a floppy disk for the driver by
use of the Toshiba Server Setup Tool.
Create the floppy disk following the procedure mentioned below.
1 Set the CD-ROM and Startup Disk of the Toshiba Server Setup Tool in the
respective drives of the server and activate the Toshiba Server Setup Tool.
2 Select “Utilities”.
3 Select “Creating FDs”.
4 Select the following name of the floppy disk and select “OK”.
DOS Disk
Adaptec 7800 Family Manager Netware
Intel LAN NetWare
5 Set a blank floppy disk in the floppy disk drive and select “OK”.
If the Startup Disk has been set in the disk drive, remove it beforehand.