HP StoreEver ESL G3 Tape Libraries - Manual (Page 51)

1. Use Table 5 to assist you in completing the elements on the IPv4 Network Configuration dialog
box.
Table 5 IPv4 Network Configuration Information
Description Element
In the Host Settings area:
If Dynamic Host Configuration Protocol (DHCP) is enabled on your network,
select Enable to have DHCP automatically configure the library network settings.
Enable makes the IP Address, Subnet Mask, and Default Gateway text boxes
unavailable. Select Disable to make the IP Address, Subnet Mask, and Default
Gateway text boxes available for you to manually set the library network set-
tings.
DHCP
The network name that you want to assign to the library. Library Name
The IP address of the library. This text box is available only if DHCP is disabled. IP Address
The subnet mask. This text box is available only if DHCP is disabled. Subnet Mask
The IP address of the default gateway for your portion of the Ethernet network.
This text box is available only if DHCP is disabled.
Default Gateway
In the Port Settings area:
Select Enable to have the library automatically negotiate port speeds. Enable
makes the Speed options unavailable. Select Disable to make the Speed options
available for you to manually set the port speed.
Auto Negotiate
The port speed (10 Mbps or 100 Mbps). Speed options are available only if
Auto Negotiate is disabled.
Speed
The Cycle button enables you to cycle the external Ethernet interface without rebooting the library.
2. Make the appropriate network configuration changes, and then click OK.
A message appears that informs you that network connectivity will be lost temporarily, and asks
whether you want to proceed.
3. Click Yes.
Setting up IPv6 Network Configuration
After completing steps 1 through 3 of Setting up the Network Configuration , the Static IP tab of the
IPv6 Network Configuration dialog box appears:
HP Enterprise Systems Library (ESL) G3 Tape Library 51