HP StoreEver ESL G3 Tape Libraries - Manual (Page 149)

5 Maintaining the library
This chapter describes common library maintenance operations.
NOTE:
If you are experiencing system problems, check subsystems and components before looking for a
service event or contacting technical support. Your service representative might ask you to check these
things or, if you are an administrator, you might be asked to run a diagnostic procedure or upload
new firmware.
Configuring and Testing Drives
The Drives dialog box enables you to do the following:
• Set speed and connection parameters
• Reset drives
• Cycle power to drives
• Take drives online or offline
• Identify drives
• Run a pass/fail test for LTO-type drives
• Eject tape cartridges from drives
• Send drive logs by e-mail or save them
• Clean drives
Viewing the Drive dialog box
Drive information on this dialog box is automatically refreshed whenever a drive is added or removed.
To use the Drive dialog box:
1. Log on as an administrator.
2. Make sure that you are viewing the physical library. From the View menu or in the Managed
Views region of the LMC, click the name of the physical library.
3. Click Tools > Drives.
The Drives dialog box appears.
HP Enterprise Systems Library (ESL) G3 Tape Library 149