Powering off the library, Powering on the library, 119 powering on the library – HP StoreEver ESL G3 Tape Libraries User Manual
Page 119
3.
Select Shutdown to do a complete shutdown and power off of the library (from the OCP only),
or select Reboot to do a reset of the library without powering off (from the OCP or a remote client
LMC).
A message appears that asks you whether you want to continue.
4.
If you are sure that all library operations are finished, click OK.
NOTE:
To recover from library shutdown, you must cycle power on the library (power it off and then
power it on). See
and
.
When the shutdown process completes, the LMC display turns dark. The library is now ready to be
powered off.
Powering Off the Library
CAUTION:
Always perform the shutdown procedure before powering off the library. Shutdown prepares the
library operation system and firmware for when you physically turn off power to the library. If you
do not perform library shutdown before you power off the library, loss of data could occur. See
Shutting Down/Rebooting the Library
To power off the library:
1.
After starting the shutdown process, wait for the LMC display to turn dark.
2.
To turn off power to the library, press the Power button on the indicator panel.
3.
On the power distribution units, set the circuit breaker switch to the down (O) position.
Powering On the Library
To power on the library:
1.
Make sure that you wait 5 minutes after powering off the library before you power it on.
HP Enterprise Systems Library (ESL) G3 Tape Library
119