HP StoreEver ESL G3 Tape Libraries - Manual (Page 174)

• IP Magazine Count
• For each type of drive: Drive Count
Drive Inventory
This inventory list provides the following information about each drive:
• Drive Type
• Interface (FIBRE)
• Physical SN
• Logical SN
• FW Version
• Sled SN
• Sled App Version
• Sled Boot FW
Test Results
The results of all sub-tests appear on the Verification Tests dialog box after each individual test is
completed. See
Table 32 for an explanation of test results.
Table 32 Test Results
Explanation Test Results
Completed the test without reported errors. PASSED
Completed the test, but the system had to retry or had to skip
part of the test. A MARGINAL result is considered PASSED,
but the log should be checked to see if the marginality can be
corrected.
MARGINAL
An error has been found and needs to be corrected. A fatal
error, or an error that causes a part of the system to become
disabled, will halt the test.
FAILED
This portion of a test was incomplete due to an interruption or
a portion of the test was run (for example, no scratch tape
was used so must only use existing tapes). An incomplete will
occur when the door is opened, an abort command is issued,
or when the Robotics Enable button is pressed.
INCOMPLETE
This portion of the test was skipped. The cause is that either
a scratch tape was not present or the library was not con-
figured for the test.
SKIPPED
A warning is additional information about the test that the user
should know. For example, if a calibration failed, but the
stored offsets are analyzed, a warning should be posted that
states that the offset check might not be accurate.
WARNING
The test was interrupted. The log will show the result to provide
a record of test interruption.
STOPPED
Maintaining the library 174