Entering license keys – HP StoreEver ESL G3 Tape Libraries User Manual
Page 32
4.
Use the buttons at the bottom of the wizard dialog box to navigate to the procedures you want
to perform. The procedures available from the Setup Wizard are:
•
• Setting up partitions (see
, and
)
•
Enabling or disabling IPv6 and IPv4 network configuration
•
Configuring the host name using the Setup Wizard
•
Specifying the date and time using the Setup Wizard
Entering License Keys
Enable license keys in the following situations:
•
During initial installation and configuration of the library (See the HP Enterprise Storage Libraray
(ESL) G3 Installation Guide)
•
During a capacity on demand (COD) or feature upgrade.
•
When you need to activate additional storage slots in your current COD configuration.
•
When enabling certain reporting functionality
•
When enabling ESKM (See
for specific instructions.)
If you cannot locate the license instructions shipped with the library, you can obtain them by contacting
HP Support.
NOTE:
Authorized service personnel are involved in the first two situations. However, any administrator can
activate additional storage slots.
To enable licenses:
1.
Log on as an administrator.
2.
If you are not already working from the physical library, select it from the View menu.
3.
From the menu bar, click Setup > Licenses.
NOTE:
To perform this procedure from the Setup Wizard, select Setup > Setup Wizard, then click Next
until the Licenses dialog box appears.
Only run the Setup Wizard to perform initial library configuration. Use the appropriate other
menu option to modify the configuration.
The Licenses dialog box appears.
Modifying the Library Configuration
32