Create new job- enter first point screen – Spectra Precision Survey Pro v5.0 User Manual
Page 8
Note: To use a scale factor with a job, go to the
card to configure the scale factor mode. If you select a
mapping plane coordinate system, your scale settings will automatically be configured.
, where you can select a control file to load into the new job.
(Cancel): cancels the creation of a new job and brings you back to the
Create a New Job – Select Control File Screen
Use a Control File: check to import control points into the new job.
[Browse…]: allows you to select a .JOB or a .SURVEY file to import control points from.
[
Select Coordinate System Screen
, where you can specify the coordinate system to use for the new
job.
Create a New Job – Select Coordinate System Screen
Select Coordinate System: check to select a coordinate system from the database. Leave this box unchecked if you
are doing a survey in a flat earth plane coordinate system.
Note: If you are doing a GNSS survey and there is no projection and no datum to relate your local coordinates to
latitude, longitude and height, then leave this box unchecked and the GNSS survey will start in Default Ground
Calibration mode.
If [Select Coordinate System] is checked, select the coordinate system from the data base using the following
controls:
[Region]: select the coordinate system region.
[Zone]: select the coordinate system zone.
[Datum]: displays the datum for the selected zone, or, allows you to select a datum for zones in the database that have
no preset datum.
[Use Geoid]: check to use a geoid model with the selected coordinate system.
[Geoid]: select the geoid model to use with the zone when [Use Geoid] is checked.
[
Next >]: opens the
where you can enter a coordinate for your first point in the new job.
Create a New Job – Enter First Point Screen
Enter First Point: when this box is checked, the additional fields will appear allowing you to create a new point.
Survey Pro Help 5.00
8