Station setup - known point, Known point, Station setup known point – Spectra Precision Survey Pro v5.0 User Manual
Page 69
Station Setup Known Point
The following screens are used when the setup type is set to Known Point.
Station Setup Known Point – Enter Occupy Point
+ Occupy Point: Select a point to setup on. You can enter a point name, select from a list or from the map. If you
enter a new point name here, you will have to enter known coordinates for that point and store it before proceeding
with the wizard.
2D Survey: Check this box to conduct a 2D survey. This option will allow you to select a 2D point for the occupy
point, and will disable the height of instrument and rod controls in setup and measurement taking user interface.
Information: Shows the location (N, E, Elev) and description of the selected occupy point.
HI: Enter the height of instrument if you are doing a 3D survey.
[Remote Elevation]: This button is available when using 3D survey Mode. Tap this button to open the
screen where you can calculate the height of the instrument from a shot on the rod on a different point.
[Check Setup]: This button is only available when there is already a station setup in place. Tap Check Setup to open
the
screen.
page.
Station Setup Known Point – Orient Instrument
New Point/BS Point/BS Azimuth: Select the type of backsight used to orient the instrument. You can choose
between:
Station Setup Known Point – Orient Instrument – New Point
BS Azimuth / BS Bearing: Enter the azimuth or bearing to the new backsight point.
Backsight Circle: Enter the circle reading you would like to set on the backsight line.
[Read Circle]: Tap to read the circle from the instrument
[Send Circle]: Sends the entered Backsight Circle to the instrument.
Fixed Target / Roving Target: Select the target type at the backsight point. Choose fixed target if you will use a
dedicated target at the backsight. Choose Roving Target if you will use the same target at the backsight as you will for
foresight points.
HR: Enter the height of the backsight target.
[Measure Backsight]: Triggers a measurement from the total station, and stores the new backsight point.
[Finish]: Records the setup and exits the wizard.
Survey Pro Help 5.00
69