Spectra Precision Survey Pro v5.0 - Manual (Page 103)

Status: displays information about the recording. It will be one of four values
No Communication: Not receiving a response to commands.
No Data: Receiving an unknown or a bad response to commands.
Recording: A file on the receiver or in the data collector is open and recording GNSS raw data. If this receiver
monitors sessions, this field will display: session in progress when a session is ongoing.
Not Recording: No file is open and there is no raw data recording.
Last Site ID: Displays the Site ID of the current session if a session is in progress. If your receiver does not monitor
sessions, the Site ID is the last Site ID used by the software.
Interval: Displays the current recording interval set in the receiver.
Remaining: Displays the time remaining in the current session if a session is in progress. This field only shows when
your receiver times sessions counting down.
Elapsed: Displays the time elapsed since this receiver was put into static mode, if a session is in progress. This field
only shows when your receiver times sessions counting up.
Free Memory: Displays the amount of memory remaining on the disk where post processing data is stored. This will
usually be the receiver’s built in memory or the receiver’s removable memory card. For some brands and models, this
may be disk space on the data collector.
HDOP: / VDOP: / Satellites Used: / Satellites Locked: See the Receiver card.
Sky View
The Sky View card displays a plot of the satellites tracked and the elevation mask boundary.
SV Used: / SV Lock: See the Receiver card.
Elev Mask: Displays the elevation mask for satellite tracking currently set on the General card of the Receiver Settings
screen.
Reset Mask:
Elev Mask: Displays the elevation mask currently set on the General card of the Receiver Settings screen. For
receivers that support changing the elevation mask outside of receiver setup, you can enter a new value here and tap
[Reset Mask].
Reset Mask: Changes the current elevation mask to the value entered in the Elev Mask field.
Note: If the receiver setup has not yet been performed, the elevation mask will not be displayed. Also, if you have
changed the elevation mask setting, and have not yet reconfigured this receiver, the value you see on this display will
be the value from the settings, and not the value the receiver is currently using.
Sat Info
The Sat Info card displays signal quality information for the satellites used by the receiver, and allows you to disable
tracking specific satellites, which is useful if the receiver is tracking a ‘noisy’ satellite.
Survey Pro Help 5.00
103