Cell / ip modem card post process card – Spectra Precision Survey Pro v5.0 User Manual
Page 102
The Data Link card displays information about the base to rover communications when the modem is a radio.
Modem Reception: Displays two values indicating the data modem signal quality. This information is only displayed
if the receiver is in rover mode.
Signal Latency: Displays the age of the differential correction used in the current GNSS solution. This value should
be one second or less for good RTK solutions. If this value is consistently greater than one second, check the data
modem link.
Reception: Displays the receiver’s estimation of the percent quality of the radio link.
Modem Settings: Displays the current modem settings
Channel: The radio modem channel.
Sensitivity: Displays the modem sensitivity (squelch).
Configure Modem...: Opens the
screen where you can change the radio channel and sensitivity
settings.
Cell/IP Modem
The Cell/IP Modem card displays information about the base to rover communications when the modem is a cell
phone or internet modem.
Modem Reception: Displays two values indicating the data modem signal quality. This information is only displayed
if the receiver is in rover mode.
Signal Latency: Displays the age of the differential correction used in the current GNSS solution. This value should
be one second or less for good RTK solutions. If this value is consistently greater than one second, check the data
modem link.
Reception: Displays the receiver’s estimation of the percent quality of the radio link.
[Dial]: Dials the cell phone or IP modem using the configuration set in the
or
screen, respectively.
[Hang up]: Disconnects the cell phone or IP modem connection.
Post Process
The Post Process card displays information about GNSS raw data logging for post processing.
Note: Some GNSS receivers monitor post processing session status while others simply record event markers in the
log file. If your receiver does not monitor sessions, some fields are not displayed.
Survey Pro Help 5.00
102