Spectra Precision Survey Pro v5.0 - Manual (Page 142)

[Stakeout] [Stake List of Points] Edit List
The Edit Point List screen is used to modify the existing point list.
[Remove]: removes the selected point from the point list.
[Clear All]: removes all the points from the point list.
[To Closest]: is available only when the screen is accessed with the [Change Design Point…] button. This will
automatically select the point in the point list that is nearest to the previously staked point, which is the selected point
when the screen if first accessed.
[<- Insert] / [<-Append]: will insert the point specified in the corresponding field above the point selected in the
point list. When is selected, the point is appended to the end of the list.
[Change to]: is available only when the screen is accessed with the [Change Design Point…] button. This is used to
stake the point currently selected in the point list.
Stake to Line
[Stakeout] [Stake to Line]
The Stake to Line screen allows you to locate any location in relation to a predefined line. The line can be defined by
two points, a point and direction, a polyline or the centerline of an alignment. Distance, direction and cut/fill
information is provided so the rod can locate the line by traveling the shortest possible distance (a perpendicular offset
to the line).
[> Define Line] / [> Polyline]: When set to [Define Line] (shown here), a line can be defined by two points or a
point and a direction. When set to [Polyline], (shown below) the line is defined by an existing polyline.
Start Point: defines the first point of the line to be staked.
[> Point] / [> Direction]: defines the second point on the line, or the direction of the line to be staked, respectively.
Begin Station: defines the station associated with the Start Point.
[Tap Line…]: displays a map of all the polylines and alignments in the current job. Simply tap the line that you want
to stake to and then tap
.
[To/From…]: opens a window where a line can be defined by a range of points.
[Backsight…]: opens the Station Setup screen.
[Stake>]: takes you to the second Stake to Line screen.
Stake to Line- Screen 2
The second screen is where the staking is performed. The graphic display of this screen will change depending on how
close the rod is to the specified line. The initial screen, that is displayed before a shot is performed, shows the position
of the total station, the line of the backsight and the specified line to stake. Each type of graphic is displayed below.
Survey Pro Help 5.00
142