Start static – Spectra Precision Survey Pro v5.0 User Manual
Page 132
Files can be selected from this list to delete or copy/move to the data collector.
Connected To: The drop-down list shows the current connection mode. The states are Receiver and SD Card:
If you change from SD Card to Receiver, the system attempts to connect to the active receiver. If this fails, or if
the active receiver is not a Trimble receiver or the Spectra Precision Epoch 25 receiver, a message appears, and
the setting reverts to SD Card.
If the change is successful the file list is repopulated with the appropriate files.
[Download Selected]: Tap to downloads the selected files to \Survey Pro Jobs.
Delete After Download: Select to delete the files after they are successfully downloaded to \Survey Pro Jobs.
Note: If your connection is to the SD card, or a Trimble receiver with firmware greater than version 3.8, a message
appears to warn you that it is not possible to reverse the deletion.
[Delete Selected]: Deletes the selected files from the receiver. If your connection is to the SD card, or a Trimble
receiver with firmware >= 3.8, then you see a message warning you that there is no undelete.
Recoverable Files tab: Lists the details of all the files on the receiver that were recently deleted. Files can be selected
from this list and recovered.
Recover Selected File(s): Restores the selected files on the receiver.
Start Static
[Survey] [Start Static]
When you are starting a static post processing survey you will first be prompted to select a receiver with the
screen.
Connect to Post Process
The Connect to Post Process screen is used to select a receiver capable of post process data logging. The function and
interface of the list of receivers is described in the
[Connect >]: Connects to the selected receiver and checks the post processing session status for that receiver. If the
receiver is not currently logging data, the
screen opens. If the receiver is currently logging data,
the
prompt will appear.
Post Processing Start
The Post Processing Start screen is used to select the recording interval and begin logging on the receiver.
Recording Interval: Select the recording interval for post processing data collection.
Start Static: Start a post processing log file in Static mode, where the receiver will remain over a single point for the
duration of the session. Once the file is begun, the
screen opens.
Start Stop/Go: Start a post processing log file in Stop and Go mode, where the receiver will move between points,
Survey Pro Help 5.00
132