beautypg.com

Configure port settings and flow control, Configure ieee 802.3x global flow control – NETGEAR MS510TXPP 8 Port Gigabit PoE Managed Switch User Manual

Page 89

background image

Smart Managed Pro Switches MS510TX and MS510TXPP

Configure Switching

User Manual

89

Configure Port Settings and Flow Control

You can configure global flow control for all ports and view, configure, and monitor the port
information for individual ports.

From the

Switching > Ports

menu, you can access pages that are described in the following

sections:

Configure IEEE 802.3x Global Flow Control on page

89

Configure the Port Settings on page

90

Configure IEEE 802.3x Global Flow Control

Flow control helps to prevent data loss when the port cannot keep up with the number of
frames being switched. When flow control is enabled, the switch can send a pause frame to
stop traffic on a port if the amount of memory used by the packets on the port exceeds a
preconfigured threshold and responds to pause requests from partner devices.

The paused port does not forward packets for the period of time specified in the pause frame.
When the pause frame time elapses, or the utilization returns to a specified low threshold, the
switch enables the port to again transmit frames.

To configure port settings:

1.

Connect your computer to the same network as the switch.

You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.

2.

Launch a web browser.

3.

In the address field of your web browser, enter the IP address of the switch.

If you do not know the IP address of the switch, see

Access the Switch on page

14

.

The login window opens.

4.

Enter the switch’s password in the

Password

field.

The default password is

password

.

The System Information page displays.

5.

Select

Switching > Ports > Global Configuration

.

The Global Configuration page displays.

6.

Next to Global Flow Control (IEEE 802.3x) Mode, enable or disable IEEE 802.3x flow control

on the system:

Enable

. The switch sends pause packets if the port buffers become full. That is, flow

control is enabled.

Disable

. The switch does not send pause packets if the port buffers become full. That

is, flow control is disabled. This the default setting.